Chasing an Agressive Spark Cut for your Ecotec powered vehicle? Look no further, our BeeR Spark Cut Conversion Kit allows you to use a genuine Nengun Performance BeeR Spark Cut module on your ecotec!
Our kit is designed to be plug and play with any Ecotec powered commodore from VS onwards that uses a DFI module. Simpily connect the patch loom in and route the wiring, that's the entire install. The BeeR also provides an adjustable RPM Limit setpoint, Two Step function and adjustable gain to control the agression of the limiter (Cut Speed).
With our patch loom, an optional button and additional mini loom is also included in case you wish to make use of the 2-step function.
Full Kit Contents:1x Genuine BeeR Rev Limiter Module
1x Custom DFI patch in loom
1x Two Step Add in Loom with Button
1x Install instrutions
(VS-VY) BeeR Spark Cut Conversion Kit
This Limiter Module is not intended for use on road and should be used off road only.
For best results and vehicle longevity:
Factory exhaust systems are highly discouraged when using this module as damage may occur to the restrictive factory catalytic converter, excess heat can also be produced by the factory catalytic converter when using this module. For best results, an aftermarket exhaust system with a High Flow, low cell count catalytic converter is recommended.
In order to use this module to limit RPM beyond 5500RPM. A tune is also required to remove the factory fuel cutoff.
Exceeding 6000RPM is HIGHLY DISCOURAGED on factory engines.